Skip to content
(817) 589-7101

Dallas · Dallas County

Hydraulic Pump & Motor Repair in Dallas, TX

A1 Hydraulic Power Solutions provides hydraulic pump & motor repair for Dallas from our Fort Worth shop — 25 miles away, about 30 minutes by road. Same-day turnaround on most work, fair quotes checked against real stock, and a counter that answers the phone: (817) 589-7101.

Dallas contractors keep us in the rotation for hard-to-match fittings and honest lead times — thirty minutes on I-30 beats a week of waiting.

Get a quote(817) 589-7101

Route card — Dallas

Distance
25 mi
Drive time
≈ 30 min
From
Fort Worth 76118
County
Dallas

Serving Dallas's commercial construction, demolition, logistics operations.

Scope

What Dallas crews get.

  • Failure diagnosis: pressure, flow, case-drain, and contamination checks
  • Gear pump and motor reseal and rebuild
  • Vane and piston unit repair or exchange sourcing
  • System contamination assessment after a failure
  • Replacement matching for obsolete or import units

Process

How it goes.

  1. 01

    Diagnose

    We test before we tear down — half the 'bad pumps' we see are relief valves, couplings, or starved inlets.

  2. 02

    Rebuild or source

    Economical rebuilds done in-house; otherwise we match a replacement, including metric-shaft import units.

  3. 03

    Protect

    We flush recommendations and filtration advice so the new unit doesn't eat the last failure's debris.

Hydraulic Pump & Motor Repair in Dallas — FAQs

Do you offer hydraulic pump & motor repair in Dallas?

Yes — Dallas is inside A1's core service area, 25 miles (about 30 minutes) from our shop at 2201 Handley Ederville Road, Fort Worth. Counter service, delivery, and on-site work are all available during business hours.

How fast can A1 respond to Dallas?

Parts and assemblies are usually ready same-day at the counter; for on-site work in Dallas, response typically falls within the same business day — call (817) 589-7101 for a real-time answer.

Which Dallas industries does A1 support?

Dallas work commonly comes from commercial construction, demolition, logistics operations — plus any crew running hydraulic equipment in Dallas County.

Why is my hydraulic pump noisy?

The usual causes are cavitation (starved inlet), aeration (suction leak), or worn internals. Noise plus heat plus slow actuators usually means wear; we can test it.

Can you repair import or metric pumps?

Yes — metric shafts, BSP and metric ports, and DIN mounts are everyday work for us, and we stock the adapters to install them cleanly.

Rebuild or replace a hydraulic pump — which is cheaper?

Gear units are often cheaper to replace; piston units usually justify rebuilding. We quote both with real numbers so you can decide.