Skip to content
(817) 589-7101

Fort Worth · Tarrant County

Hydraulic Pump & Motor Repair in Fort Worth, TX

A1 Hydraulic Power Solutions provides hydraulic pump & motor repair for Fort Worth from our Fort Worth shop — 9 miles away, about 15 minutes by road. Same-day turnaround on most work, fair quotes checked against real stock, and a counter that answers the phone: (817) 589-7101.

Our shop sits inside Fort Worth city limits on Handley Ederville Road, so most of the city — from the Cultural District to the industrial parks off Loop 820 — is one short hop away.

Get a quote(817) 589-7101

Route card — Fort Worth

Distance
9 mi
Drive time
≈ 15 min
From
Fort Worth 76118
County
Tarrant

Serving Fort Worth's manufacturing, aerospace and defense, rail operations.

Scope

What Fort Worth crews get.

  • Failure diagnosis: pressure, flow, case-drain, and contamination checks
  • Gear pump and motor reseal and rebuild
  • Vane and piston unit repair or exchange sourcing
  • System contamination assessment after a failure
  • Replacement matching for obsolete or import units

Process

How it goes.

  1. 01

    Diagnose

    We test before we tear down — half the 'bad pumps' we see are relief valves, couplings, or starved inlets.

  2. 02

    Rebuild or source

    Economical rebuilds done in-house; otherwise we match a replacement, including metric-shaft import units.

  3. 03

    Protect

    We flush recommendations and filtration advice so the new unit doesn't eat the last failure's debris.

Hydraulic Pump & Motor Repair in Fort Worth — FAQs

Do you offer hydraulic pump & motor repair in Fort Worth?

Yes — Fort Worth is inside A1's core service area, 9 miles (about 15 minutes) from our shop at 2201 Handley Ederville Road, Fort Worth. Counter service, delivery, and on-site work are all available during business hours.

How fast can A1 respond to Fort Worth?

Parts and assemblies are usually ready same-day at the counter; for on-site work in Fort Worth, response typically falls within the same business day — call (817) 589-7101 for a real-time answer.

Which Fort Worth industries does A1 support?

Fort Worth work commonly comes from manufacturing, aerospace and defense, rail operations — plus any crew running hydraulic equipment in Tarrant County.

Why is my hydraulic pump noisy?

The usual causes are cavitation (starved inlet), aeration (suction leak), or worn internals. Noise plus heat plus slow actuators usually means wear; we can test it.

Can you repair import or metric pumps?

Yes — metric shafts, BSP and metric ports, and DIN mounts are everyday work for us, and we stock the adapters to install them cleanly.

Rebuild or replace a hydraulic pump — which is cheaper?

Gear units are often cheaper to replace; piston units usually justify rebuilding. We quote both with real numbers so you can decide.