Skip to content
(817) 589-7101

Keller · Tarrant County

Hydraulic Pump & Motor Repair in Keller, TX

A1 Hydraulic Power Solutions provides hydraulic pump & motor repair for Keller from our Fort Worth shop — 14 miles away, about 20 minutes by road. Same-day turnaround on most work, fair quotes checked against real stock, and a counter that answers the phone: (817) 589-7101.

Keller's builders and utility crews run skid steers and mini-excavators hard; we stock the compact-equipment hose ends that keep them moving.

Get a quote(817) 589-7101

Route card — Keller

Distance
14 mi
Drive time
≈ 20 min
From
Fort Worth 76118
County
Tarrant

Serving Keller's residential construction, landscaping, utility contractors operations.

Scope

What Keller crews get.

  • Failure diagnosis: pressure, flow, case-drain, and contamination checks
  • Gear pump and motor reseal and rebuild
  • Vane and piston unit repair or exchange sourcing
  • System contamination assessment after a failure
  • Replacement matching for obsolete or import units

Process

How it goes.

  1. 01

    Diagnose

    We test before we tear down — half the 'bad pumps' we see are relief valves, couplings, or starved inlets.

  2. 02

    Rebuild or source

    Economical rebuilds done in-house; otherwise we match a replacement, including metric-shaft import units.

  3. 03

    Protect

    We flush recommendations and filtration advice so the new unit doesn't eat the last failure's debris.

Hydraulic Pump & Motor Repair in Keller — FAQs

Do you offer hydraulic pump & motor repair in Keller?

Yes — Keller is inside A1's core service area, 14 miles (about 20 minutes) from our shop at 2201 Handley Ederville Road, Fort Worth. Counter service, delivery, and on-site work are all available during business hours.

How fast can A1 respond to Keller?

Parts and assemblies are usually ready same-day at the counter; for on-site work in Keller, response typically falls within the same business day — call (817) 589-7101 for a real-time answer.

Which Keller industries does A1 support?

Keller work commonly comes from residential construction, landscaping, utility contractors operations — plus any crew running hydraulic equipment in Tarrant County.

Why is my hydraulic pump noisy?

The usual causes are cavitation (starved inlet), aeration (suction leak), or worn internals. Noise plus heat plus slow actuators usually means wear; we can test it.

Can you repair import or metric pumps?

Yes — metric shafts, BSP and metric ports, and DIN mounts are everyday work for us, and we stock the adapters to install them cleanly.

Rebuild or replace a hydraulic pump — which is cheaper?

Gear units are often cheaper to replace; piston units usually justify rebuilding. We quote both with real numbers so you can decide.